Hondata

My Hondata has been working fine since the beginning of the year. I had Eric's Racing Install it. Church Automotive Dyno Tuned car and everything has been perfect. Today i start the car and its running rich as hell, check engine light on, and Ecu showing a solid Red Light. I have tryed to read ecu and it shows its conected but i dont see any of my sensors reading like rpm and voltage etc. What do i do next.

Serial #s300-13104
P28 US spec Ecu
RC 550 Injectors
NGK Platium Spark Plugs
Aem Cold Air Intake
Skunk2 Alpha Series Headers
LS Bottom end with Crower stroker Crank
B16a Head With Springs and Retainers
Jun stage 3 Cams
Stroked to a 2.0
Je Pistons

I am also useing the most current version Smanger. I Can upload files, and when i do the light goes green, but as soon as i start it dies and goes RED. I messed with it uploading the supplied calibrations and then loaded mine, and it was fine for 15min, drove to the store and when i went to restart it RED and car ran like shit. Had to have the car towed.

send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions:

Name:
Address:
Phone:
Email:
Serial#: