Page 1 of 1
2002 s2000 kpro to Motec CDL comms question
Posted: Sat Jul 14, 2012 6:43 pm
by PaddyMcP
2002 rsx ecu/kpro in a 2002 S2000
Trying to use the serial output to send display data to motec dash via serial comms. Which pin is this exactly? E24 refers to an rsx ecu... But this one is the handata which has been changed to work with s2000 harness.
Re: 2002 s2000 kpro to Motec CDL comms question
Posted: Sun Jul 15, 2012 6:36 am
by PaddyMcP
oem ecu serial # 37820 prb a05
kpro serial # none on the case, don't know where this is located. Bought 7/1/2012
K Manager Software rev 3.1.2
car details, 2002 S2000 with oem engine
Is there a full pinout list that references the S2000 engine loom for this configuration?
Re: 2002 s2000 kpro to Motec CDL comms question
Posted: Mon Jul 16, 2012 8:37 am
by Hondata
The serial output (E24) is not connected to the S2000 connector. If you wish to use it you will need to solder onto the ECU board connector.
Re: 2002 s2000 kpro to Motec CDL comms question
Posted: Mon Jul 16, 2012 12:19 pm
by PaddyMcP
Thank you. What pin is it on the board?
Re: 2002 s2000 kpro to Motec CDL comms question
Posted: Mon Jul 16, 2012 4:28 pm
by Spunkster