Hondata

Hi .
I tried several times to upload any new Cal but it doesn't work .
say"upload fail , please try angain"

The S300 is conected to PC and I get all the info of the hondata ;
-Serial
-Mem test Ok etc..

The hondata board light is green

I do not get the datalog infos (ect and iat are wrong)

Smanager version is 2.1.1
S300 V2 serial Number 20335
Windows 7
Ecu is P75 chipped by xenocron .

I was able to erase the hondata but didn't change anything .
Thank's for yout help

Has J12 been cut on the ECU?

yes .

Make sure that the s300 board is seated on the pins properly.

Hi , the hondata is propely seated in the ecu , I really don't know what to do .

Was this previously working then stopped?

No it as never worked.
It was bought new from a shop .

What is the serial number on the s300 board inside the ECU? From Help, About, what is the version of software you are using?

Smanager version is 2.1.1
S300 V2 serial Number 20335
Windows 7
Ecu is P75 chipped by xenocron .

Have you tried the s300 in a different ECU?

I will try it
(thought that xenocron test them but I'm not sure )