Hondata

So I updated to v1.2.8 today and now my FlashPro will not connect to FlashPro Manager. FP Manager prompts me that the calibration on my FlashPro is from a previous version of FlashPro Manager. So I click Help > Update USB Drivers. After that, I get the box saying that it's going to update my drivers, make sure the FP is plugged in, and I may need to restart. I click okay, i get a box saying the FP firmware will be updated, wait a few seconds, and then I get another box. This box says USB Driver updated, but i cannot click okay. If i do, FP Manager just freezes and i have close it and start the whole process over. I've tried going to the device manager and uninstalling the driver and deleting it from my computer then downloading it from Hondata.com. I've tried uninstalling FP Manager and then downloading/installing again. I've tried every combination... i do not know what to do. I need this up and running as soon as possible because my car is running very very rich and i need to do some logs for my tuner (Vitaliy).

Windows 7 Home Premium 32bit
Intel Atom CPU N270 @ 1.6Ghz
HP Mini 110

Don't use 'update usb drivers' (the update message concerned the calibration stored on the FlashPro, not the drivers).

Follow the manual USB installation instructions here: http://www.hondata.com/help/flashpro/in ... indows.htm

I've tried that many times but it gets stuck and freezes after I get the pop up saying "The Flashpro firmware will be updated". I just tried it as per the instructions in the help file and this is where I got stuck.

If it is saying that the firmware needs to be updated then the drivers are already installed and you do not need to do anything with the drivers.