Hondata

i bought a 96 civic with a b18c1 turbo somewhat recently and i hooked up my computer to maybe do some fine tuning and now my car wont even stay running. which is disappointing since i dont think i even changed anything... could you guys check out my calibration and see if there is any glaring error that would cause that? i would appreciate it enormously. since this car is supposed to be my dd.

stock injectors?

i was told 440. but the calibration says 240. i tried changing that but that didnt help.

try and mess with the overall fuel trim and see if that helps. its a bandaid, but it may help get your car running.

i just tried that and it didnt really change anything. i can keep it running if i keep punching the gas pedal so it doesnt die. but it bogs down if i try to hold it and stinks something horrible. its definitely not running anywhere near right. any other ideas?

Ive seen this happen before. Is the motor built or stock?

built. eagle rods, supertech valve springs, mahler pistons, 9.5:1 compression.

figured that was it... I bet it has something to do with the compression...

stock cam gears/cams at 0/0?

Stock gsr gears. Not sure about timing

Its looking like I accidentally wiped the calibration... it was trying to use a stock one which obviously didn't work. I just need one good enough to get to the exhaust shop and tuners. What stock map should I start with? For a built turbo b18c1

any help would be appreciated... just need a map good enough to get it running. i tried using the b18c5 revhard map and just tune the fuel but i didnt see any change. still wouldnt run. i really need some help im pretty lost here...

Well thanks for all the help. Not. Might as well delete don't need it anymore