Hondata

Just checked your base calibrations (for example with RDX 410cc inj.) for Acura TSX and found that all which has CAM agles 0 10 20 30 40 has immobilizer disabled flag. Uploading it to ECU Flashpro Pop-up warning that immo can't be disabled. Can you make all calibrations equal with immo enable by default.

Already has been fixed.

Hondata wrote:Already has been fixed.

today found one interesting error, all your default maps with 0 10 20 30 40 Cam angles can't go past VTC 20 degree, tried to enter in low and high VTC tables 30 and 40 degrees.

The standard VTC goes to 25 degrees. Some people replace the VTC with a RSX 50 degree version.

Hondata wrote:The standard VTC goes to 25 degrees. Some people replace the VTC with a RSX 50 degree version.

I know that standard goes till 25 degree. In my car VTC is 50 degree and your standart calibrations with CAM agles 0 10 20 30 40 has bug, impossible to go more then 20 degree. Look in datalog and low VTC table.

Yes, you're right, the cam angle seems limited to 20 degrees for some of the calibrations. The 2004-2005 base calibrations goes to 50.

Try out this calibration.

Hondata wrote:Yes, you're right, the cam angle seems limited to 20 degrees for some of the calibrations. The 2004-2005 base calibrations goes to 50.

Try out this calibration.

now it can go above 20 degrees, but I got VSA error in dash even it was checked in calibration and immobilizer still disabled.