Hondata

Posted: **Tue Feb 28, 2012 1:40 am**

Hello guys.
My car is 07 european s2000 so I'm using Flashpro and Innovate MTX-L series wideband.And It has two analog outputs.
I'm planning to connect my ecu to wideband for closed and open loop operation.But I dont know excatly Which pin should I use for connection on ecu.Does anyone tell me ? Thanks

Posted: **Tue Feb 28, 2012 9:44 am**

Use ECT2 (pin E1).

Posted: **Tue Feb 28, 2012 10:53 am**

You can only run in closed loop using the factory wideband. It will not run in closed loop with a aftermarket wideband input.

Posted: **Tue Feb 28, 2012 10:55 am**

Should I disable second ect sensor on Flash pro ? And Sould I splice or cut cable for connection ?

Posted: **Tue Feb 28, 2012 10:56 am**

Spunkster wrote:You can only run in closed loop using the factory wideband. It will not run in closed loop with a aftermarket wideband input.

So I have to use first oxygen sensor for it ? Am I right ?

Hondata

Which pinout from ecu ?

Which pinout from ecu ?

Re: Which pinout from ecu ?

Re: Which pinout from ecu ?

Re: Which pinout from ecu ?

Re: Which pinout from ecu ?