Hondata

Heres the setup, THANKS IN ADVANCE :)

K20Z3 11.7:1 WISECO SHELFS
-DECKED & MILLED SLIGHTLY
-STOCK RBC HEAD
-RBC MANIFOLD
-HYBRID RACING CAI
-DC SWAP HEADER
-3" EXHAUST

just for now, I want to load a basemap I get here onto my buddies kpro just to see how it is, only issue is his basemap was made with a older version of k manager. Can someone assist me in what I need to do so I can load the one you give me, test it, then be able to go back and reload his basemap that he has now back on seeing that his car is his daily, I dont want to leave him with a non running car.

His setup:

K20A2 (STOCK)
-SRI
-DC SWAP HEADER
-RBC
-3" EXHAUST

Im sure theres a basemap for his setup in k manager but not sure about mine.. Any help is appreciated, Thanks!

Honda plugs are hot, amber color of the porcelain looks about right.

Lighter on the electode where heat can not dissitpate but carbon on threads where it can.


Maybe my standards are different, but these plug to me wouldnt warrant a second look.

cukali wrote:Honda plugs are hot, amber color of the porcelain looks about right.

Lighter on the electode where heat can not dissitpate but carbon on threads where it can.


Maybe my standards are different, but these plug to me wouldnt warrant a second look.

Thanks, got my kpro last night. I noticed a slight "knocking sound" now after using a basemap from kmanager, anyway to rid this easily without a full tune? Also, I still have a CEL for the following codes:

-p0134 secondary oxygen sensor
-VTEC malfunction / oil pressure switch

however, both of them seemed to be disabled in the .kal?

bump for a z3 basemap!


help?

UPDATE: I've uploaded a few datalogs and the kal im using hoping someone can help...

here ya go - http://www.hondata.com/forum/viewtopic.php?f=14&t=13857

bump for some help