Hondata

Anybody can explain if this correct green connector ? Above glove box apartament, didn't had a tester to check :)

угу
http://www.hondata.com/downloads/04-06_ ... nstall.pdf

sass wrote:угу
http://www.hondata.com/downloads/04-06_ ... nstall.pdf

found myself :)

Hi Zoro2006 sorry to border you but i recently bought a tsx ecu and a flashpro and i am about to do the CAN programming adapter installation on my 2006 accord 2.4 executive( german version) and i followed the instructions and unmounted the glove box but like you i have two green connectors:number 1 and 2 in the picture that i attached,so my question is did you use the number 1 connector or the number 2 connector as described in the hondata manual :
http://www.hondata.com/downloads/04-06_ ... nstall.pdf

also i wanted to ask you did you do it exactly as described in the hondata manual or did you use an other approach(i am asking cause if i have to do it following the hondata manual and use connector number 2, i would have to solder the two wires to the green connector cause on my green connector there is no empty spot),and also is there something else(except everything mentioned in the hondata manual) i should do before going to the honda dealer for the VIN and immobilizer matching.

once again sorry to border you.thanks a lot best regards Todor

lamerchebg wrote:Hi Zoro2006 sorry to border you but i recently bought a tsx ecu and a flashpro and i am about to do the CAN programming adapter installation on my 2006 accord 2.4 executive( german version) and i followed the instructions and unmounted the glove box but like you i have two green connectors:number 1 and 2 in the picture that i attached,so my question is did you use the number 1 connector or the number 2 connector as described in the hondata manual :
http://www.hondata.com/downloads/04-06_ ... nstall.pdf

also i wanted to ask you did you do it exactly as described in the hondata manual or did you use an other approach(i am asking cause if i have to do it following the hondata manual and use connector number 2, i would have to solder the two wires to the green connector cause on my green connector there is no empty spot),and also is there something else(except everything mentioned in the hondata manual) i should do before going to the honda dealer for the VIN and immobilizer matching.

once again sorry to border you.thanks a lot best regards Todor

number 2

or a bridge on the can bus just before the ecu in the center lower dash ....like i do with solder and clips.... less effort and cut on hands