Page 1 of 1
can we run the k pro with no high speed speedo signal
Posted: Mon Feb 06, 2012 6:22 pm
by bigal
K-Pro .If we do not require a signal to drive a speedo can we run sucessfully with or without a signal from the high speed speedo drive using a low speed engine harness or do we need to swap out the harness as well.
Re: can we run the k pro with no high speed speedo signal
Posted: Tue Feb 07, 2012 3:39 pm
by Hondata
The 2002-2004 (low frequency) harness does use the same VSS connector as the 2005+ (high frequency) harness. Usually the easiest route is to use the 2002-2004 transmission case with vss.
Re: can we run the k pro with no high speed speedo signal
Posted: Tue Feb 07, 2012 3:46 pm
by Spunkster
Read the information in the tech section of the website:
http://www.hondata.com/techk20transmissions.html
Re: can we run the k pro with no high speed speedo signal
Posted: Tue Feb 07, 2012 3:57 pm
by bigal
yes have been through all this
will kpro [using low speed engine harness] run ok without a speed sensor signal ?
ie connected but not being driven
will lack of speed sensor or speed sensor signal affect operation of vtec ?
Re: can we run the k pro with no high speed speedo signal
Posted: Tue Feb 07, 2012 4:07 pm
by Spunkster
You must have a properly functioning speed sensor signal going into the ECU.