Hondata

Posted: **Tue Jan 03, 2012 7:55 pm**

My car has no spark when the S300 is used. It had done this once before and I fixed it by erasing the ecu and re-uploading the settings. This lasted less than 24 hours before I ran into the same problem. I put my stock ecu in and spark works fine. This is using the stock h22a configuration included with the SManager software. I see nothing (and smell nothing) burnt. Could it be a bad ecu? After all it is from 1994.
Thanks!

Posted: **Wed Jan 04, 2012 10:23 am**

Try the s300 in a different ECU to see if it is just a damaged ECU. This is the most likely cause of the problem.

Posted: **Wed Jan 04, 2012 3:42 pm**

Ok, thanks.

Hondata

No Spark with S300, Stock ECU works fine.

No Spark with S300, Stock ECU works fine.

Re: No Spark with S300, Stock ECU works fine.

Re: No Spark with S300, Stock ECU works fine.