Hondata

So i got my flashpro yesterday for my 08 s2k.
I didn't do much with it. I just lock it to my ecu, registered it, and loaded up some calibrations to look at.
I didn't change anything, didn't upload anything to the ecu.
But this morning, the engine only rev to 7k.
Am I somehow in diagnostic mode?
I have tried to return back to stock, and upload the stock equivalent calibration.
all said sucessful. but still only 7k rev limit.

Pleas help me... what did i do wrong, and how do i fix it.
Thanks

Start by telling us what vehicle you have (yes, I can see 08 s2k, but they sell them all over the world). It also would help to know the ECU part number. Next check for any error codes. Then make a short datalog showing the problem, and post it here.