Hondata

Hi
I've a dc5 itr with a built k24 block with stock itr head
Here are my parts:-
Stock itr head with skunk2 titanium retainers
Forged cp pistons 89mm bore 11.2cr
Forged crower rods
Rc 760cc injectors
Obx 4-1 long tube race type header
Custom 3" exhaust
K&n short ram intake

Can anyone help with sending me a map so i can compare notes because my tuner has a strong believe that 220hp is more than enough for my build.
I am willing to pay for a copy of somebody's map with a similar k24 build.
I have attached a link i created at k20a.org seeking help

http://www.k20a.org/forum/showthread.php?t=97449

Which dyno were you using?

Dynojet

playaz97 wrote:Hi
I've a dc5 itr with a built k24 block with stock itr head
Here are my parts:-
Stock itr head with skunk2 titanium retainers
Forged cp pistons 89mm bore 11.2cr
Forged crower rods
Rc 760cc injectors
Obx 4-1 long tube race type header
Custom 3" exhaust
K&n short ram intake

Can anyone help with sending me a map so i can compare notes because my tuner has a strong believe that 220hp is more than enough for my build.
I am willing to pay for a copy of somebody's map with a similar k24 build.
I have attached a link i created at k20a.org seeking help

http://www.k20a.org/forum/showthread.php?t=97449

playaz97
Did you write this log "k24 k20 hyrbid 220hp.zip" on the road or dyno stand?
What is your transmission?
And what size wheels?

i was on the dyno then
i am not sure what tranny i have but whatever came with the original dc5 type-R's, that is what i have