Hondata

Hello

KPro serial number: 05004866
37820-PRB-A05 ECU
k20a2 engine N \ A
K-manager 3.0.3
Stock injectors \ 63mm exhaust \ intake filter \ DC5 cams \ intake manifolds PRC
swap honda civic EC9
all right so far.
k-manager version 1.5 gave me problems to 5500rpm limiter
tps -1%


the problem started when I was loading the mapping.
loading the mapping and is stuck in the middle, unfortunately the PC and downloaded and then switched off.

when I turned on I tried to reload the map, unfortunately

I do not enable the loading of the map \ lightning \ erase ECU etc..

can only qualify me for the encounter snow-KPro-information. nothing more ...


If I insert the USB KPro, the car lights \ AFR 10,6:1 \ engine light comes on .. KPro and the lights are solid green \ red light flashing

If you do not insert the USB, the drive turns on without any error. Engine light is turned off ..
solid green \ red light off.

can you help me?

the problem and the KPro or the PC?

when i used k manager version 3.0.3 my car wouldn't start, so i've uploaded a map using version 1.5.1 but got stuck with a 5500 rev limiter as well.
As of yesterday i have had the same issue. my pc is detecting that the krpo is connected but it wont communicate.
i've tried uninstalling kmanager and usb drivers, ive tried reinstalling differnt version of kmanager and also usb drivers.
nothing seems to work.

luckily my kpro still has the map i uploaded from version 1.5.1, my car still drives with a 5500 rev limiter

could this be a BUG in the new kmanager software ? or a dead kpro..

I hope to get some response from Hondata ..

Please follow the posting guidelines.

Hondata wrote:Please follow the posting guidelines.

Where can I find these guides lines?

rilsolvere you can explain to me how this problem?

I can not do anything at the end, I can not clean the map, I can not upload \ or take a datalog. , The boxes are disabled.

Yea, i'd like to know where to find these posting guidelines?

Also, I hope hondata is just as concerned with the problems their customers are bringing to their attention just as much as following the posting guidelines : ) [thinking out loud]

The posting guildlines are found under Before posting in this forum read this

If you want to help us solve the problem then provide the information rather than trolling.

a datalog, I can not do because it is completely blocked.
I can not record data \ view \ and I can clean and refresh the mapping ..

In fact I say that as soon as I installed the 3.0.3 kmanager I had this problem.


KPro number: 05004866 ..

the other data I've already written ..


As I said, and a swap honda civic .. EC9
I followed your wiring diagram, so good, no errors.

then the problem started when I updated the version 3.0.3,
When I had version 3.0.0 was fine ..