Hondata

Posted: **Mon Sep 26, 2011 12:28 pm**

Is it possible to configure the overrun cutoff and recover parameters in flashpro so that we can continue to inject fuel on overrun? May be usefull for piston/valve cooling during very agressive running etc.

Thanks

Dan (EDM S2000)

Posted: **Mon Sep 26, 2011 7:56 pm**

Adding overrun fuel will wash down the bore so that the ring seal will go away. The engine has oil jets for piston cooling.

Hondata

Fueling on Overrun (for piston/valve cooling)

Fueling on Overrun (for piston/valve cooling)

Re: Fueling on Overrun (for piston/valve cooling)