Hondata

I'm totally new to kpro and just installed it in my 03 RSX base. I loaded up the k20a3 (91 octane) base map and went for a run and did a little datalog. Went into 3rd gear and tried to go WOT but it went into limp mode (i think) since it wouldn't let me rev past 3500rpms and went limp after that until i pressed the clutch and changed up gear.

Any particular reason why it would do that? And what do I look for at this point? I'm totally lost and would appreciate any input I can get.

[edit] added another, much longer datalog in hopes of it helping