D16y1/D16z6 won't idle after engine swap.
Posted: Tue Aug 02, 2011 7:59 pm
Hey guys,
Recently did an engine replacement on my EG hatch
D16y1 running Hondata s300
High flowed injectors
Bosch 044 fuel pump
t04e turbo setup w/ ext gate
etc etc
Seems it would not run with the old tune map it had on the car before the new motor was fitted (will not idle/seems to misfire - unsure why). I have since just ran a base map so the car is drivable. However because of this it is not tuned for boost and will hit boost cut at 1psi.
I can't get the car in for a tune till late next week. Anybody have any decent turbo d16y1/z6 maps for a similar set up that I can run until the car is tuned?
Or perhaps any tips/tricks so I can get it running on boost (very low boost, say 1-3 psi but just so it does not hit boost cut and is drivable on throttle).
Recently did an engine replacement on my EG hatch
D16y1 running Hondata s300
High flowed injectors
Bosch 044 fuel pump
t04e turbo setup w/ ext gate
etc etc
Seems it would not run with the old tune map it had on the car before the new motor was fitted (will not idle/seems to misfire - unsure why). I have since just ran a base map so the car is drivable. However because of this it is not tuned for boost and will hit boost cut at 1psi.
I can't get the car in for a tune till late next week. Anybody have any decent turbo d16y1/z6 maps for a similar set up that I can run until the car is tuned?
Or perhaps any tips/tricks so I can get it running on boost (very low boost, say 1-3 psi but just so it does not hit boost cut and is drivable on throttle).