Hondata

I set up a s300 and i went to test out the s300 if it was working, then i put in a map and started up the car then the car started then it died after i started up the car again then i notes that the check engine light was on and stayed on i also not that the not codes were on the smanager and also no datalog was recorded... I have install s300 o other customers car and no problem this one did give me a problem.. What could i be???? im thinking that the s300 gave a shit and just died or the customer gave me a shitty computer...


Could you give me a sign of hope

thanks
ART

Try the s300 in a known good ECU. Go to File, New and upload a fresh calibration.