Hondata

i have purchased s200 & hondata obd2 to obd1 conversion ecu. this was installed & tuned on my gsr while fuel pressure was set @ around 20 psi. which it eventually died on me.

now that gsr is gone, i installed type r motor with correct fuel pressure setted.(don't wanna blow this one up) anyhow, now my question is, does hondata have pre-set tuning for type-r motor??? also, can i reset my ecu before installed in the car. since ecu was setup rich on leanning gsr motor.

Contact your dealer about getting a basemap for your setup.

any dealer recommendation in s. cal?

Look here:

http://www.hondata.com/contact.html