Meth Injection Delay Setting for Nitrous Tab
Posted: Fri Jun 24, 2011 12:11 pm
Hondata,
While using methanol injection, we usually activate the meth pump in the same method you would activate a nitrous solenoid except we are activating the methanol pump. What we are finding out is that methanol mixtures take about 0.5-1 second to actually reach the motor. Currently there is no way to delay the removal of fuel and addition of ignition at the motor when the pump is activated. The only way we can solve this problem is to increase lean cut delay to 1000ms which is on the "scary side" for some of us running 13+psi of boost. Is it possible to add another field where you can tell K-pro to activate the pump (or nitrous solenoid for comparison) and wait "X" amount of time before modifying the fuel and ignition?
A lot more people are experimenting with methanol injection lately and this has become a common issue. Thank you and this would be a GREAT addition for us.
Sam
Just realized I probably should have put this in the Kmanager section...sorry!
While using methanol injection, we usually activate the meth pump in the same method you would activate a nitrous solenoid except we are activating the methanol pump. What we are finding out is that methanol mixtures take about 0.5-1 second to actually reach the motor. Currently there is no way to delay the removal of fuel and addition of ignition at the motor when the pump is activated. The only way we can solve this problem is to increase lean cut delay to 1000ms which is on the "scary side" for some of us running 13+psi of boost. Is it possible to add another field where you can tell K-pro to activate the pump (or nitrous solenoid for comparison) and wait "X" amount of time before modifying the fuel and ignition?
A lot more people are experimenting with methanol injection lately and this has become a common issue. Thank you and this would be a GREAT addition for us.
Sam
Just realized I probably should have put this in the Kmanager section...sorry!