Page 1 of 1
Hondata K-pro "upload failed, erase failed"
Posted: Fri May 27, 2011 1:12 am
by lemmiwinks
So I purchased a DC5 PND ECU with a brand new K-pro fitted. When I try to upload a calibration or erase, i get a "upload / erase failed" error.
The software detects the ECU and says "online, and ignition on" at the bottom of the screen. But I just can't erase or upload.
Software is up to date.
Any help would be great!
Re: Hondata K-pro "upload failed, erase failed"
Posted: Fri May 27, 2011 10:04 am
by Spunkster
Where did you purchase this from and what is the serial number?
Re: Hondata K-pro "upload failed, erase failed"
Posted: Fri May 27, 2011 10:33 am
by lemmiwinks
Purchased privately. Not sure where it was installed. Will get serial no. Once I get home.
Re: Hondata K-pro "upload failed, erase failed"
Posted: Fri May 27, 2011 11:37 am
by lemmiwinks
Serial number of ecu is 37820-pnd-a06 2062-602400. Also has some other numbers written on the ecu case: 590-59317
Re: Hondata K-pro "upload failed, erase failed"
Posted: Fri May 27, 2011 1:43 pm
by Spunkster
Please email a picture of the inside of the ECU to support <at> hondata.com.
Re: Hondata K-pro "upload failed, erase failed"
Posted: Fri May 27, 2011 4:27 pm
by lemmiwinks
Spunkster wrote:Please email a picture of the inside of the ECU to support <at> hondata.com.
email sent.