Hondata

Hi there,

I'm tuning a S300 for a friend. Is installed on a P30 board so it don't have knock control.
Despite of that, i was wondering if it is possible to wire the knock sensor to a spare 0-5v input to see/datalog the raw voltage it produces as a resonant-type one.

Regards.

No, this is not possible.

Touge Master wrote:Hi there,

I'm tuning a S300 for a friend. Is installed on a P30 board so it don't have knock control.
Despite of that, i was wondering if it is possible to wire the knock sensor to a spare 0-5v input to see/datalog the raw voltage it produces as a resonant-type one.

Regards.

buy an after knock box which has 0-5v analogue out