Page 1 of 1
done research still cant find wideband problems
Posted: Sun May 22, 2011 6:52 pm
by brutal_redrum
im running a hondata ecu and s300 and i cant get my wideband to read in the program... analog2 shows e243 at all times using pin d6... i need help asap thank you...
Re: done research still cant find wideband problems
Posted: Sun May 22, 2011 6:55 pm
by brutal_redrum
running b18c with forged internals and arps top to bottom other then that its stock
Re: done research still cant find wideband problems
Posted: Mon May 23, 2011 10:09 am
by Spunkster
You need to provide details such as how you have it hooked up, brand of wideband...etc. Also calibrations and datalogs showing the problem would help.
Re: done research still cant find wideband problems
Posted: Mon May 23, 2011 11:01 am
by brutal_redrum
Sorry I'm new to this and have never used hondata... its an aem ugeo... wired into b6 on a hondata ecu... I'll try to get my calibration up as soon as possible... its my friends car I'm just helping him tune it
Re: done research still cant find wideband problems
Posted: Wed Jun 22, 2011 5:25 pm
by burmese434
Could you use the eld d10 pin? Make sure your using the white wire coming off the gauge. Also disable the eld in the parameters.