Hondata

Posted: **Wed May 11, 2011 4:53 am**

Hey!

Got a p28 and a s300 i bought a while ago. When i was going to start the car last week with the s300 in the p28 it runed on a very high load of fuel and a very low idel. So i opened the box, took out the s300 and cut the J1 jumper and tryed to start the car again and it was the same problem. Anyone had the same problem? Bad ecu? Got constant engine light and red diode light from the ECU.

Posted: **Wed May 11, 2011 9:32 am**

Have you tried uploading a calibration to the s300?

Posted: **Wed May 11, 2011 9:41 am**

Spunkster wrote:Have you tried uploading a calibration to the s300?

Yes it uploads perfect and the SManger says "online".

Posted: **Wed May 11, 2011 10:23 am**

From Help, About, what version of software are you using?

Posted: **Wed May 11, 2011 11:55 am**

Spunkster wrote:From Help, About, what version of software are you using?

The latest one, downloaded it today.

Posted: **Wed May 11, 2011 12:05 pm**

that does not tell me the version number

Posted: **Wed May 11, 2011 12:43 pm**

Spunkster wrote:that does not tell me the version number

1.4.8.0

Posted: **Wed May 11, 2011 4:02 pm**

There are more recent beta version of software available in the downloads section of our website. If the ECU is not working in stock configuration then it is either a faulty ECU or there is a problem with the socketing of the ECU.

Hondata

p28 with s300 problem

p28 with s300 problem

Re: p28 with s300 problem

Re: p28 with s300 problem

Re: p28 with s300 problem

Re: p28 with s300 problem

Re: p28 with s300 problem

Re: p28 with s300 problem

Re: p28 with s300 problem