Hondata

Hello:
I'm using Smanager 1.4.8 and I' been trying to get my fan working with the A-20 output. I've tried deifr\erent settings on the conditions tab and nothing seems to work. Everytime I turn my ignition on my fan turns on and never stops until my switch is off. I'm using an external relay since my factory harness is in bad shape. I wired the relay using the A-20 output as a ground signal. My settings in the conditions tab are:

Min Max
500----9000 rpms
10------120 Kpa load
0% --------------Throttle
0--------60mph
100*f Air Temp
170-----200F coolant

Any suggestion are appreciated..... Thanks

It sounds like you have it wired incorrectly if it is always on with the ignition turned on. The output does work correctly with a properly wired car as I have it working on my car using the factory wiring and relay.

Why are you not using the fan control option in the Protection tab?

I'm using the Nitrous Auxiliary Output-3 for fan control, with an external relay since my factory harness is in bad shape...