Page 1 of 1
IAT, ECT compensation for ignition in FD2R
Posted: Mon Apr 25, 2011 10:44 am
by engjoo
Dear Hondata,
What tradeoffs will we have for not having the IAT and ECT compensation for ignition for the FD2R ?
Does IAT/ECT compensation for ignition exist in the factory calibration of the FD2R?
Re: IAT, ECT compensation for ignition in FD2R
Posted: Tue Apr 26, 2011 8:35 am
by Hondata
I've never had to change these tables.
Use the race calibration if you want to change the ECT and IAT ignition compensation.
Re: IAT, ECT compensation for ignition in FD2R
Posted: Tue Apr 26, 2011 9:03 am
by engjoo
Hondata wrote:I've never had to change these tables.
Use the race calibration if you want to change the ECT and IAT ignition compensation.
But they do not even exist to begin with. Or is it 'there' but u don't 'see' it ?
Re: IAT, ECT compensation for ignition in FD2R
Posted: Tue Apr 26, 2011 9:59 am
by Spunkster
Make sure you go to Options and click on show advanced parameters.
Re: IAT, ECT compensation for ignition in FD2R
Posted: Tue Apr 26, 2011 4:41 pm
by engjoo
I did that but IAT/ECT compensation for ignition is not there:
Re: IAT, ECT compensation for ignition in FD2R
Posted: Tue Apr 26, 2011 5:09 pm
by Hondata
Hondata wrote:Use the race calibration if you want to change the ECT and IAT ignition compensation.
Re: IAT, ECT compensation for ignition in FD2R
Posted: Tue Apr 26, 2011 5:10 pm
by engjoo
Why are there only 10 load columns in the following calibration?
Civic-Si-RRC1
Civic-Si-RRC1-Reflash
How do import tables from the above into the race calibration?
I have seen that the knock tables are also different in the race calibration. Which is the correct one for the FD2r?
Re: IAT, ECT compensation for ignition in FD2R
Posted: Wed Apr 27, 2011 8:57 am
by Hondata
The RRC calibrations are not expanded for boost - you'd need to use the race calibration for forced induction.
Tables can't be directly imported because of the difference in column count, as you probably have found out. If you want the RRC knock ignition limit tables in the race calibration then you'll need to copy and paste the first 10 columns, then replicate column 10 across the rest of the table.
Re: IAT, ECT compensation for ignition in FD2R
Posted: Wed Apr 27, 2011 4:49 pm
by engjoo
Hondata wrote:The RRC calibrations are not expanded for boost - you'd need to use the race calibration for forced induction.
Tables can't be directly imported because of the difference in column count, as you probably have found out. If you want the RRC knock ignition limit tables in the race calibration then you'll need to copy and paste the first 10 columns, then replicate column 10 across the rest of the table.
Why are the knock tables different ? How was the knock tables derived? Which one is the closest to our Factory knock tables?
Re: IAT, ECT compensation for ignition in FD2R
Posted: Thu Apr 28, 2011 9:43 am
by Hondata
The RRC calibrations are closest to factory.