k24A2 DC5 stalls when throttle is applied
Posted: Wed Apr 20, 2011 6:40 pm
KManager v1.4.1.0
2002 Acura RSX-S
K24a2 Swap
KPro
E85 fuel
Open header
09 TSX Pistons, Forged Rods, Z1 Intake Cam with 50 degree VTC Gear, Walbro 255lph Fuel pump, RC 750cc injectors, Type-S oil pump, Complete Type-S wire harness.
Problem: --------------------------------------------------------------------------------
Just swapped a k24a2 into my RSX and got everything back together. Now the car turns over fine and will idle as long as I let it but as soon as I apply some throttle after it's warmed up the RPMs drop and the car shuts off. After this happens I can get the car to start but it immediately shuts back down. I have replaced my fuel pump and battery. I've checked the voltage of the battery while the car is running to see if the alternator is charging it and I am getting 13-14 volts. If I let the car sit for a while it will start back up and idle for a while until I apply throttle...repeat. Can anyone point me in the right direction as to what to do next?
Note: The calibration seems to be locked by the tuner so it is not allowing me to upload it.
2002 Acura RSX-S
K24a2 Swap
KPro
E85 fuel
Open header
09 TSX Pistons, Forged Rods, Z1 Intake Cam with 50 degree VTC Gear, Walbro 255lph Fuel pump, RC 750cc injectors, Type-S oil pump, Complete Type-S wire harness.
Problem: --------------------------------------------------------------------------------
Just swapped a k24a2 into my RSX and got everything back together. Now the car turns over fine and will idle as long as I let it but as soon as I apply some throttle after it's warmed up the RPMs drop and the car shuts off. After this happens I can get the car to start but it immediately shuts back down. I have replaced my fuel pump and battery. I've checked the voltage of the battery while the car is running to see if the alternator is charging it and I am getting 13-14 volts. If I let the car sit for a while it will start back up and idle for a while until I apply throttle...repeat. Can anyone point me in the right direction as to what to do next?
Note: The calibration seems to be locked by the tuner so it is not allowing me to upload it.