Page 1 of 1
Unable to datalog
Posted: Mon Apr 04, 2011 4:23 am
by comish71
I have a k-pro setup ecu prb a05, # on kpro board is E199143 94V-0 (no clue what this means)
setup is k20head/k24
I am unable to datalog unless I do it manually. If I set the datalog parameters for "based on engine parameters" and upload this to the ecu, when I check the ecu, it never uploads the "based on engine parameter changes."
Hondata is version 14.1.0.
Thanks.
Posted: Mon Apr 04, 2011 9:49 am
by Spunkster
What is the serial number on the K-Pro? It is on a sticker with a bar code.
Posted: Mon Apr 04, 2011 7:41 pm
by comish71
serial # 37820 prb a05
2068-501089 0j25
Posted: Tue Apr 05, 2011 9:11 am
by Spunkster
I need the serial number that is on the K-Pro board inside the ECU.
Posted: Tue Apr 05, 2011 8:12 pm
by comish71
i do not have a bar code on the kpro board. there is no specific number onn the board. i have a serial # for ecu which is in an above post.
Posted: Wed Apr 06, 2011 9:56 am
by Spunkster
Post a good, in focus picture of the inside of the ECU, including the K-Pro board.
Posted: Wed Apr 06, 2011 2:17 pm
by comish71
here are pics
Posted: Wed Apr 06, 2011 2:19 pm
by comish71
here are pics
Posted: Wed Apr 06, 2011 2:58 pm
by Spunkster
This K-Pro does not have on-board datalogging. You can only datalog using a laptop.
The serial number has been removed, this usually indicates that it is stolen.
Posted: Wed Apr 06, 2011 3:17 pm
by comish71
Well I can assure you it's not. As a matter of fact I've got my receipt and the shop that I bought it from is very reputable (one of your dealers). Now back to the more important matter at hand, is there an upgrade that can be done to the kpro so that I can datalog?
Posted: Wed Apr 06, 2011 3:43 pm
by Spunkster
If it had a serial number yes, but since it does not, we cannot offer any upgrades.
Posted: Wed Apr 06, 2011 6:47 pm
by comish71
If I have the receipt and verification from your distributor/dealer that this is their unit then would I be able to upgrade the unit? Apparently there is an issue here that occurred before I obtained the unit and therefore out of my control.
Posted: Thu Apr 07, 2011 9:17 am
by Spunkster
No, I'm sorry, but we do not upgrade systems without serial numbers.