Hondata

Posted: **Wed Mar 23, 2011 8:04 pm**

this is the second this has happened to me with the same car.
as soon as i went to start the car with the s300 freshly installed, the R135 transistor burned out. im not getting any datalog because of this.

does anyone have any clue on why this might be happening?

this is s300 on a p28 in a 94 civic with a z6

any help would be greatly appreciated.

Posted: **Thu Mar 24, 2011 9:38 am**

That is not component R135, it is Q31. You have the IAT and Purge connectors swapped. You may also have burned out the IAT sensor.

Posted: **Thu Mar 24, 2011 4:15 pm**

Is that transistor replaceable? If so would you know the type or part number?

Posted: **Fri Mar 25, 2011 9:31 am**

Fix your wiring problem, cut off the burned transistor and don't worry about it. It is just for the purge.

Posted: **Fri Mar 25, 2011 12:57 pm**

Thanks a lot

Posted: **Sat Mar 26, 2011 8:01 am**

Any reason why I'm not able to datalog?

Posted: **Mon Mar 28, 2011 9:29 am**

Does it datalog with the key on, but the engine not running?

Posted: **Mon Mar 28, 2011 9:48 am**

Nope no datalog at all

Posted: **Mon Mar 28, 2011 11:20 am**

Has J12 been cut on the ECU?

Posted: **Mon Mar 28, 2011 12:37 pm**

Yes. I had datalog working before the transistor fried

Posted: **Mon Mar 28, 2011 1:47 pm**

Try the s300 on a known good ECU.