Need a calibration for my k20a2 setup!!!!!!

[byront]

Im new to the tuning world and still learning but id like to get a nice tune on it for now until i get tuning fully under my belt...

*I know this setup is built for boost but i decided to go all motor and im building a 2.4 block so for now im just gona play*


MY SETUP:

K20a2 block
10:1 wesico pistons
pauter rods
castillo crank (bigger bearings)
erl mid sleeved

K20a2 head
crower stage 2 cams
supertech valves,retainers,springs,seals

skunk2 replica header
RBC manifold
accord throttle body