Page 1 of 1
How do you disable the seconday o2 in FP
Posted: Wed Feb 23, 2011 5:14 pm
by Swiftoy
I am a noob and after uploading a calibration in my s2000 I could not figure out how to disable the sensor. I could use some help
Thanks
Swiftoy
Posted: Wed Feb 23, 2011 5:32 pm
by Spunkster
It's under closed loop in the calibration window.
Posted: Wed Feb 23, 2011 5:51 pm
by Swiftoy
So do I just uncheck the box with flashpro plugged into the car and computer and thats it? Do I need to reflash the toda program again?
And thank you for your help
Swiftoy
Posted: Wed Feb 23, 2011 5:52 pm
by Spunkster
Any time you make changes, you must upload the calibration to the ECU.
Posted: Wed Feb 23, 2011 5:59 pm
by Swiftoy
So let me be clear on this do I go into the calibration window disable it then reflash the toda calibration again I'm a bit confused can you elaborate a little more. I dont want to screw something up.
Thank you
Posted: Fri Feb 25, 2011 3:37 am
by nunoctr
1- uncheck the box
2- save the cal
3- upload
4- Good to go.