Hondata

Running a k20z1 with Kpro..

I was under the impression when you disable boost control in kpro with a Hondata Boost Solenoid, it will automatically run off of the wastegate spring b/c its a normally closed application...

I have hondata boost controller disabled in kpro so I can run off the wastegate pressure.. And it creeps "SOMETIMES" in 3rd gear around 3000rpms-5000rpms only....

I have posted a KAL and 2 datalogs....

It works fine when bc is enabled....
It also works fine in 3rd gear above 4000rpms with bc disabled as you can see in datalog 1...

Any ideas Spunkster?

It is pretty rich, and ignition has some room to grow during spool up.

Fix those two and your creep will more than likely be more controlled.

thanks, its a street tune that i been working on.... I guess, I still have alot to learn from the master... LOL I will adjust those values u talked about.. I added too much fuel compensation for lower iats b/c i used always run a tad lean during cold temps.. And since its been cold, it dumped alot more fuel...