Page 1 of 1
Revhang w/ flashpro
Posted: Tue Dec 21, 2010 6:46 pm
by coast
I'm not really good in english but I will do my best.
My car is Honda Civic SI 2008 w/ I/E/H + flashpro
I noticed that when I run the car normally (shift ~4000rpm) I got little revhang. I have to wait about a second before my rpm drop
BUT, when I shift in higher RPM (6000-7000rpm) my rpm drop really quick like it always should be.
I do a video
Did you think that something is possible to help my problem?
Thanks!
http://www.youtube.com/watch?v=3d6F3ZrkQqY
Posted: Wed Dec 22, 2010 9:49 am
by Hondata
What calibration are you using?
Posted: Sat Dec 25, 2010 8:41 pm
by coast
Hondata wrote:What calibration are you using?
My tuner use the map K&N V2 + race header + s+highflo cat + stock catback as a basemap that he custom tune for my setup on the dyno
But the trottle plate was not changed.
Posted: Tue Dec 28, 2010 8:56 am
by Hondata
What vehicle do you have and what calibration are you using (there are more than one calibrations with that description)?
Posted: Mon Jan 03, 2011 4:26 pm
by coast
Hondata wrote:What vehicle do you have and what calibration are you using (there are more than one calibrations with that description)?
My car is Honda Civic SI 2008
My calibration is K&N V2 air intake + Race header + HFC + Stock catback
Posted: Tue Jan 04, 2011 9:31 am
by Hondata
Which calibration ?
Civic-Si-RRB-5-KNSRI-RH or Civic-Si-Race-6-KNSRI-RH ?
Posted: Wed Jan 05, 2011 3:09 pm
by coast
Hondata wrote:Which calibration ?
Civic-Si-RRB-5-KNSRI-RH or Civic-Si-Race-6-KNSRI-RH ?
Sorry. :oops:
Civic-Si-Race-6-KNSRI-RH
Posted: Thu Jan 06, 2011 2:19 am
by mucter
Tune your part throttle fuel and overrun fuel and the rev hang will go away completely. It's because you're dumping fuel in overrun sometimes and it will keep the car from revving down.
You can also play with the Overrun cutoff settings under Calibration > Throttle to see if those help.