Hondata

ok just downloaded version 1.4.1 and now the car wont start. it had a version 1.4.0 map on it. i tried to tune it again after i downloaded new version and now the car wont start. i refuse to believe the ecu is damaged becasue it start great before i uploaded the 1.4.1 version on it.

motor
k20a2
basic bolt ons
kpro

is this happening to anyone else? what can i do to get it to start again.

ok i found out it was the new 1.4.1 software because i got a friends laptop with the 1.4.0 software uploaded a base map and the car started up great. no problems. Could u guys please review the 1.4.1 version it seems better and more improved versus the older 1. thank you

Try clearing secutity using the new version then upload your calibration.