Page 1 of 1
Help with ELD error code
Posted: Tue Nov 09, 2010 6:04 pm
by cantresjr
ok here is the background. JDM B16. S-300j. base p30 map. wide band connected to ELD.
Should the ELD be disabeled or enabeled. i get a ELD error code when i enable the ELD and the car runs crappy
how should i really set it up?
thanks
Bog
Posted: Wed Nov 10, 2010 1:22 am
by Johnny_9
is the car bog standard (wiring) or is a hybrid? is the fuse box standard or have any relays/fuses been modified?
Posted: Wed Nov 10, 2010 10:11 am
by AREA876
Only the wideband should be connected to ELD wire and ELD disable. Please tell if the wideband and hondata readings are the same.
Re: Bog
Posted: Wed Nov 10, 2010 10:11 am
by cantresjr
Johnny_9 wrote:is the car bog standard (wiring) or is a hybrid? is the fuse box standard or have any relays/fuses been modified?
the car is a 1989 crx with OBD0 to OBD1 harness adapter. all fuse boxes and the rest of wiring is stock
Posted: Wed Nov 10, 2010 10:16 am
by cantresjr
AREA876 wrote:Only the wideband should be connected to ELD wire and ELD disable. Please tell if the wideband and hondata readings are the same.
OK, so when the wideband is connected to the ELD input, on the hondata the ELD should be disabled. is this correct?
i have noticed that the hondata reads leaner than the XD-16. but i want to veryfy in a dyno to see wich one is the correct reading.
Posted: Wed Nov 10, 2010 11:19 am
by AREA876
OK, so when the wideband is connected to the ELD input, on the hondata the ELD should be disabled. is this correct?
i have noticed that the hondata reads leaner than the XD-16. but i want to veryfy in a dyno to see wich one is the correct reading.[/quote]
Yes that's correct.
Is your wideband a innovate band? if so use logwork to see the correct AFR reading, then use the voltage offset to correct hondata AFR reading.
Posted: Wed Nov 10, 2010 11:31 am
by AREA876
cantresjr wrote:
OK, so when the wideband is connected to the ELD input, on the hondata the ELD should be disabled. is this correct?
i have noticed that the hondata reads leaner than the XD-16. but i want to veryfy in a dyno to see wich one is the correct reading.
Yes that's correct.
Is your wideband a innovate band? if so use logwork to see the correct AFR reading, then use the voltage offset in Smanager to correct hondata AFR reading.
Posted: Wed Nov 10, 2010 1:06 pm
by cantresjr
AREA876 wrote:cantresjr wrote:
Is your wideband a innovate band?
if so use logwork to see the correct AFR reading, then use the voltage offset in Smanager to correct hondata AFR reading.
Yes it is an innovate system.
I'll do that. thanks. altough it looks like the voltage offset coutld be a lot. when hondata sees stoich my gauge reads low 13. sometimes high 12's
thanks a lot.