Hondata

Hey, i tried uploading a changed configuration to my kpro but after upload, and redownloading it it doesnt show as changed. I sometimes get a memory access violation error, and the datalogging doesnt seem to work either.

Is this a problem with me using windows 7 or am i doing something wrong?

It's a PRA ecu, when i try to upload any changes like a simple checkmark setting, or the injector size, it says uploading with the bar for around 1 sec, then when i download to verify it'll be unchanged.

Also i lose the connection to the kpro after uploading usually.

I've updated and ran the "check usb drivers"

Downloading is not recommended, especially to check parameters. Close the program, reopen it and then load your calibration, make your changes, save the file and upload it to the ECU.