Hondata

I get the following message every time i try to upload a program: "Please switch the ignition on if you wish to upload the ECU. Otherwise the calibration will be uploaded to the flash pro only"

I have done the removal and complete turning off of the equipment and then restarting. I have tried several laptops reinstalling the software and drivers per Hondata instructions. The vehicle does not start.

The calibration loads onto the flashpro, but does not load into the vehicles ecu. Has anyone had this problem? We spoke to Javier at Hondata yesterday and he told us to remove the equipment and connect/restart to see what would happen, but this has been done many times with no luck. Where do we go from here?

Any feedback will be greatly appreciated.

Regards,
Mark Perez
Import Performance
Puerto Rico

What vehicle is this in, and what has been done to the vehicle since the last time it successfully uploaded? What version of software are you using from Help, About?

The vehicle is a 2007 Honda Civic Si. The last thing done was modification to the 30 degree BTC fuel tables and this was the last successful upload to the ecu. The software version used for this was the latest version, 1.1.6.7

Curiosly a scan tool was placed in the OBD2 port of this vehicle and the scan tool cannot communicate with the vehilce ecu.

What else mechanically or physically has been done to the ECU since the last successful upload?

Nothing has been done to the ecu since its last successful upload.

Sorry I meant to the vehicle, not the ECU....anything, changed spark plugs, changed engine mount....ANYTHING.

Also at the bottom of the FlashPro Manager screen what does it show in the bottom left?

Nothing has been done or changed to the engine or any of its components.

At the bottom of the flashpro manager screen there is a checkmark on
OBD2/Flashpro and on ecu there is an "x"

Ecu/Flashpro unit will be shipped over to you guys as Javier to us to send it over. Javier said that maybe the system is locked.

read how to recover the ecu its in the fp manager help