Hondata

Hey i just got a S300 P28 ECU and installed it with a harness into my 96 Integra VTi-R (GSR), i loaded the 93-95 GSR Base Map, because that was the closest to my car and am having a few problems.

First Off Error Codes:

20 ELD Electrical Load Detector
23 KS Knock Sensor
41 Oxygen Sensor Heater

Second Air Fuel display is constantly red

A:F (:1)
ranges from 0.7* - 0.8*

Third is, i got told by a reputable tuner that if i really want to use the s300 for now, just upload the VTiR base map and set VTEC to 5700 because I'm using the Skunk2 IM, to do this do i just adjust the lower and upper to 5700?

My Car Info:
1996 Integra VTiR, I/H/E Skunk2 IM.

Any help would be appreciated

Thanks

you can disable the codes, go to Parameter - Misc. tab. and you can disable knock & ELD sensor. Go to close loop tab and you can disable the O2 heater.

Thanks for the reply, so those sensors aren't necessary or required?