How to Display TPS Volts?

Johnny_9 · Post by **Johnny_9** » Fri Sep 17, 2010 7:45 pm

Post by **Hondata** » Sat Sep 18, 2010 8:28 am

That page refers to the S200 software. With SManager, you can indirectly display voltage if you wish during the TPS calibration.

hdragster · Post by **hdragster** » Wed Sep 22, 2010 4:44 pm

Hondata wrote:That page refers to the S200 software. With SManager, you can indirectly display voltage if you wish during the TPS calibration.

Is there any way you guys could display the tps voltage instead of percentage?

Johnny_9 · Post by **Johnny_9** » Thu Sep 23, 2010 2:21 am

Hondata wrote:That page refers to the S200 software. With SManager, you can indirectly display voltage if you wish during the TPS calibration.

Is that s300? Is that thru the analague in voltage in?