Page 1 of 1
kpro upload fail/security fail
Posted: Mon Sep 06, 2010 11:24 am
by hazeman69
im tyring to erase ecu, and says security fail, i try to upload something, says upload fail, any advice? im using v1.4.1.0
Posted: Mon Sep 06, 2010 11:25 am
by hazeman69
its an ep3 ecu w kpro on a k20z3 motor with a k20a2 engine harness and hybrid conversion harness in a 93 civic hatch
Posted: Tue Sep 07, 2010 10:02 am
by hazeman69
anyone?
Posted: Tue Sep 07, 2010 11:07 am
by Spunkster
What is the serial number of the K-Pro board inside the ECU?
Posted: Tue Sep 07, 2010 3:02 pm
by hazeman69
Spunkster wrote:What is the serial number of the K-Pro board inside the ECU?
umm not sure where to look, opened the ecu, theres a barcode w the numbers 05004536. if i plug it into my laptop it says, hardware version 2.16 serial number 04536 firmware version 2.02 firware ok YES security disabled software version 1.4.1.0
Posted: Tue Sep 07, 2010 9:54 pm
by hazeman69
also, with the ignition on, laptop connected, ecu gets extremely hot, used another ecu w kpro, same things happened...extremely hot and couldnt upload
Posted: Wed Sep 08, 2010 7:17 am
by kb58
Hmm, that's not good, I've run the ECU for hours during debugging and it barely gets warm. Double-check that power is going to the correct pins.
Posted: Wed Sep 08, 2010 7:51 am
by hazeman69
kb58 wrote:Hmm, that's not good, I've run the ECU for hours during debugging and it barely gets warm. Double-check that power is going to the correct pins.
yeah it happened on both ecus so it cant be the actual ecu, has to be wiring somewhere, but where
Posted: Wed Sep 08, 2010 9:21 am
by Floppie
By "ignition on" do you mean the car's started or just the key's turned?
Posted: Wed Sep 08, 2010 9:38 am
by hazeman69
the key is turned to 2nd postion and k manager reads ignition on
Posted: Wed Sep 08, 2010 10:12 am
by Spunkster
You should try the ECU in a known good car.
Posted: Thu Sep 09, 2010 11:48 am
by hazeman69
getting the ecu tested tommorow
Posted: Sat Sep 11, 2010 2:26 pm
by hazeman69
ecu was fine, changed out the engine harness and everything is good, so i guess the result was bad engine harness, not sure exactly what but thanks