Page 1 of 1
Cam angle mapping question
Posted: Fri Aug 20, 2010 5:30 am
by Mask
hi guys, i would like to know if i have for ex. 35 degrees os cam angle to which table i map, it assumes the 30 degrees or the 40??
i hope i explain myself good.
thanks
Posted: Fri Aug 20, 2010 9:19 am
by Spunkster
I"m not sure I understand your question, but the maps interpolate between the values in the tables.
Posted: Fri Aug 20, 2010 11:39 am
by Mask
humm...so when i change gear the rpm falls until 7000 rpm, and at 7000 rpm i have 35 degrees of vtc and i wanted to know if with 35 it assusmes the parameters of the 30 or the parameters of the 40...so it wont be good...would be better 30 or 40 right?
Posted: Fri Aug 20, 2010 12:34 pm
by Spunkster
It interpolates between the values.