Page 1 of 1
k20z2
Posted: Wed Aug 11, 2010 7:39 am
by yeuror
what about this engine type? is available the flash pro or anything else about programming?
Posted: Wed Aug 11, 2010 9:49 am
by Spunkster
What vehicle is this and what is the ECU code?
Posted: Wed Aug 11, 2010 3:37 pm
by ajpturbopittsburgh
K20Z2
Found in:
2006- Acura CSX (Canada)
Displacement: 1,998 cc (121.9 cu in)
Compression: 9.6:1
Power: 155 hp (114 kW) @ 6000 rpm (SAE net J1349 Rev 8/04)
Torque: 139 ft·lbf (188 N·m) @ 4500 rpm
Redline: 6800 rpm
2006- Honda Civic (JDM)
Displacement: 1,998 cc (121.9 cu in)
Compression: 9.6:1
Power: 155 hp (114 kW) @ 6000 rpm
Torque: 139 ft·lbf (188 N·m) @ 4500 rpm
Redline: 6800 rpm
2006- Honda Accord(Europe)
Displacement: 1998 cc
Compression: 9.6:1
Power: 155 hp (114 kW) @ 6000 rpm
Torque: 139 ft·lbf (188 N·m) @ 4500 rpm
Redline: 6800 rpm
Posted: Wed Aug 11, 2010 3:43 pm
by Spunkster
Re: k20z2
Posted: Mon Feb 12, 2018 10:13 am
by m_leavy
Can i run a turbo setup on this engine with a PRA ecu
Re: k20z2
Posted: Mon Feb 12, 2018 10:33 am
by Spunkster
What vehicle is this in?
Re: k20z2
Posted: Mon Feb 12, 2018 12:11 pm
by m_leavy
Spunkster its hopefully going in a mazda rx8
Re: k20z2
Posted: Mon Feb 12, 2018 12:40 pm
by Spunkster
Is this drive by wire?
Re: k20z2
Posted: Mon Feb 12, 2018 1:45 pm
by m_leavy
I think it is but haven't checked yet. there are a couple of guys from Poland that have done it with the k20z4 just one is using hondata and the other is using an emu engine management system. however my polish is no good so I was looking for a pin out for a PRA ecu as I can only find picture upon picture for US compatible ecus
Re: k20z2
Posted: Mon Feb 12, 2018 5:48 pm
by Spunkster
IF it is drive by wire we do not offer anything that will work with that in an engine swap.
Re: k20z2
Posted: Tue Feb 13, 2018 2:32 am
by m_leavy
all im looking for is a pin out for the pra ecu