Hondata

Can someone please smooth out this tune
The car was dyno and street tuned ...but not very well,you can see it on the 2d and 3d fuel curves


Specs

Engine
- JDM B18C block.
-AEBS 84mm Sleeves.
-JE 10:1 Pistons
-Eagle Rods
-ARP Head Studs
-DMH Fab Custom catch can setup

Head
- ITR Head
- New valve guides
- New valve seals
- New valve job
- Inline PRO dual valve springs and titanium retainers
- Stock ITR cams

Turbo Kit
-New Precision SC6162 with the upgraded 4” inlet compressor housing. DMH Fab Ceramic coated exhaust housing.
-DMH Fab 304 stainless top mount manifold. Ceramic coated. Clears the AC compressor.
-Full 3” mandrel bent exhaust. .
-DMH Fab Aluminum 2.5” mandrel bent intercooler pipes.
- Tial 50mm blow off valve
- Tial 38mm wastegate
-650 hp front mount intercooler
-4” inlet pipe and filter
-4an stainless feed line, 10an drain line
-S300 Hondata.w/pwm boost solenoid
-2.5 motorola map sensor

Fuel/Intake
-DMH Fab Sheet metal intake manifold.
-Precision 880cc injectors
-Walbro 255 High Pressure pump.
-75mm Throttle Body

Transmission
-GSR transmission
-OBX LSD
-Competition Clutch 6 puck clutch


Cooling
-Fluidyne aluminum radiator
- FAL electric fan

Does this car have a over heating problem? because your overheating protection is higher than normal. You stated 880cc injectors but in the calibrations it say 480cc injectors. How much HP did it make on the dyno?

it made 430whp on 20psi

Its never overheated and runs pretty cool, and i saw the 480cc part and was trying to figure that out...

If you have 880cc injectors installed, you should ask your tuner why he has 480cc instead. Orginially the overheating protection was set at 220 deg F, your car rev limiter is 8223 rpm but your protection limiter is 10026 rpm, so it wouldn't be effective. After looking at both low & high ignition tables I think you should get the car retuned. If you look at 5000 rpm row in your low ignition and then at it in the high ignition you will notice the timing is down a whole lot in that area:shock:

yes i have an appointment with a reputable tuner in my area next friday...
I was just interested to get some opinions before i go up there..

Was just wondering why the fan over ride was checked to come on at 100 degrees. Also, with the previous statements about the injectors, I would verify the offset for them as well when you get it retuned. You should be able to contact the manufacturer of the injectors to get some or all the numbers you need for that. Timing looks pretty extreme towards the top at 12 to 27 pounds. I believe it was 21 down to 5.50. Your cold cut and hot cut are set to the same 30 pounds which if you are only a 2.5 bar your chances are you will not see that.

Jason

yeah when i first post this thread i was looking for someone to help smooth things outon the map... But now i'm taking all these suggestions in for future tuning.

I will post the updated tune upon completion. Thanks guys