Hondata

Posted: **Fri Jul 23, 2010 10:32 pm**

Hello, I finally got my ECU p08j ... had to ask the New Zealand ...

What I realized was that the plant is already "socket" original ... already comes with 74 373 IC latch into IC4.
comes with a SIM in IC3, which probably will have to withdraw it (of course) to put the pins male s300J ..

in J4 already has a 0 ohm resistor

already comes with a resistor Identical to that provided in the Hondata s300j C27 ..
in J1 as well, since a resistor has 0ohms ..

is that right? just put the male pins and only?

Code Central is the P08-j00, stock of MT D15b

thanks

Posted: **Sat Jul 24, 2010 9:17 am**

More Pics

Posted: **Sat Jul 24, 2010 11:46 pm**

Awaiting response from my doubts, please.
thanks

Posted: **Mon Jul 26, 2010 9:36 am**

Just remove the eeprom and install the male pins and the 4pin connector in CN2.

Hondata

p08-j00 in s300j, doubt

p08-j00 in s300j, doubt