k20z3/k20a2 map requested
Posted: Sun Jul 18, 2010 5:13 pm
right now im running the k20a2 with itr cams, header and cold air intake map that is offered by kpro. if yall think that map is good until i get it tuned then ill run that, but if not any help would be appreciated!
car:
2003 rsx type s, full interior, AC and powersteering.
setup:
k20z3 block with 8k miles on it
exedy stage 1 clutch
ACT light weight fly wheel
k20a2 head fully rebuilt
full skunk2 flat faced valve train(valves, retainers, dual springs)
skunk2 stage 1 cams
skunk2 exhaust cam gear
kiddracing header
rbc intake manifold, 70mm tb portmatched
injen cold air intake
exhaust is not installed right now bc it did not bolt up correctly. im goin to be running a stock exhaust with a cut out for the time being(being installed tom)
i have not put my RDX injectors in or wal255 just bc i do not have a map for it. im getting my car tuned in a month or so, i just need something to run it until then.
car:
2003 rsx type s, full interior, AC and powersteering.
setup:
k20z3 block with 8k miles on it
exedy stage 1 clutch
ACT light weight fly wheel
k20a2 head fully rebuilt
full skunk2 flat faced valve train(valves, retainers, dual springs)
skunk2 stage 1 cams
skunk2 exhaust cam gear
kiddracing header
rbc intake manifold, 70mm tb portmatched
injen cold air intake
exhaust is not installed right now bc it did not bolt up correctly. im goin to be running a stock exhaust with a cut out for the time being(being installed tom)
i have not put my RDX injectors in or wal255 just bc i do not have a map for it. im getting my car tuned in a month or so, i just need something to run it until then.