AFM WOT TUNING
Posted: Tue Jul 06, 2010 2:54 pm
When tuning for WOT using AFM mode, is it possible to target a 13.0 AFR?
When does it change to closed loop? Is this linked to the WOT ADJUSTMENT TABLE? If there is a 12.5 value can I still tune for 13.0 AFR?
I already calibrated the sensor for closed loop - works fine.
And for WOT targeting 13.0? Same method ?
What about the open loop check?
Sorry for the amount of questions, any information is welcome.
Thanks!
When does it change to closed loop? Is this linked to the WOT ADJUSTMENT TABLE? If there is a 12.5 value can I still tune for 13.0 AFR?
I already calibrated the sensor for closed loop - works fine.
And for WOT targeting 13.0? Same method ?
What about the open loop check?
Sorry for the amount of questions, any information is welcome.
Thanks!