Page 1 of 1
Wideband Wiring
Posted: Wed Jun 23, 2010 11:57 pm
by spoonskywalker
Hi...
I got ELD error after installing the PLX WB. Should I cut the wire from ELD and just connected the WD input from PLX WB only?? Currently I jumper the wire from PLX WB to the D10 (ELD) pin.
Posted: Thu Jun 24, 2010 9:21 am
by Spunkster
Wideband Wiring
Posted: Thu Jul 01, 2010 1:22 pm
by spoonskywalker
White 0-5V Output from wideband - connect to ELD input making sure that the ELD is no longer connected to it (ELD is pin D10 on an OBD1 ECU) <-- you mean, I have to cut the original wire? Sorry, a bit confused here...
Thank in advance
Posted: Thu Jul 01, 2010 2:22 pm
by Spunkster
yes
Posted: Thu Jul 01, 2010 11:48 pm
by spoonskywalker
Done.. I follow the wiring as per instruction but still got the ELD error when I did datalog. Any ideas?
Posted: Fri Jul 02, 2010 10:17 am
by Spunkster
In Misc Parameters, disable the ELD error.