Page 1 of 1
Autometer shift light with S300
Posted: Tue Jun 15, 2010 10:49 am
by R.A.T.
How can I hook up an autometer shift light to the S300?
Posted: Tue Jun 15, 2010 11:31 am
by Spunkster
You should follow the instructions provided with it and install it however Autometer tells you to.
Posted: Tue Jun 15, 2010 11:47 am
by R.A.T.
Spunkster wrote:You should follow the instructions provided with it and install it however Autometer tells you to.
If Im not mistaken, autometer hooks up to the ignition and uses a pills to control the rpm shift light.
Since Hondatas S300 has the Shift Light option I would like to hook up the light to my hondata in order to be able to make changes with the SManager.
Or else, what are my options for a shift light with hondata other than the "check engine" light?
Posted: Tue Jun 15, 2010 11:57 am
by Spunkster
http://www.hondata.com/downloads/s200%2 ... manual.doc
read the section on installing a shift light...it is the same for an s300.
This will not be compatible with an Autometer.
Posted: Tue Jun 15, 2010 12:21 pm
by R.A.T.
In that case, which shift light does Hondata recommend if the Autometer ones are not compatible?
Posted: Tue Jun 15, 2010 12:45 pm
by Spunkster
You can use an autometer, you just have to install it as their instructions say.
Posted: Sat Jun 19, 2010 10:39 pm
by tsiah
why not just use the CEL?
Posted: Sun Feb 06, 2011 2:51 pm
by lowblow
You probably can use MIL output to relay and then to two wire Shift Lite