Hondata

Hi lads. could someone tell me if all s300 ecu should have atmospheric presure sensors built into them as im getting funny reading from mine. if they should have, i will post datalogs and other info on car.
cheers.

What is the code on the side of your ECU?

Thanks for your quick reply. The code is p28 g01
The Hondata chip code is S300-2881
there is a p30 code on the connector of ecu

You will have to disable the baro error, and the injector error with that ECU.

Cheers , i will check tomorrow.
just to let you know about myself.
i built this engine for my customer over a year ago and he flew a tuner from the states to tune this engine.
Im a technician, so im good with EOBD but only now have i looked into Hondata .
I must do some more checks and will report back.Cheers

Again thanks for your quick reply and help.

Hi Spunkster.
I can datalog no problem but cannot check to disable errors you instructed me to do.
when i go to misc in parameter , i dont have option to check the listed options.
Could you point in right direction please

Thanks in advance for your time .

You must load your calibration into the software to be able to make changes to it. You then must upload the calibration to the ECU when done.

cheers. thanks for your help.