Hondata

hey there.
02 crv k24 in austin mini.
install is all new.
car runs.

can't seem to do anything as far as code checking or anything other than upload cals etc. cant look at data even when clicking the datalog icon, nothing happens.

i am online with ecm and it recognises key is on etc.

the car idles @ 1500-2000 rpm and wont rev over 3500. seems to be in some type of defaut limp mode or something.

the mil is on steady.

like i said cant read codes to start diagnosen?

please help! car is book to autocross sunday!!

probably had a bad upload, try clear security, wait atleast 2 minutes after clearing before attempting upload, if the upload doesn't go slow then clear security a second time.

This should make sure you get a good upload and then the car will most likely function properly.

hmm. ill try that again. when i do get it sorted, is there any tricks to pulling codes or is it as simple as start dataloging then click on fault codes?